Cannot build Slicer source after windows repair install

classic Classic list List threaded Threaded
2 messages Options
Viz
Reply | Threaded
Open this post in threaded view
|

Cannot build Slicer source after windows repair install

Viz
Hi,

Unfortunately, I had to do a repair install of Windows, following which I can no longer build my source. Is there an easy way to get it compiling again?

So far, I installed CMake and added it to PATH. Also, I had a copy of PATH values for my old system, which I added to my current PATH. My Perl, Python and Qt installation folders seem to have been preserved just as they were before, so I did not reinstall/rebuild either of them.

Thanks,
Viz.
Reply | Threaded
Open this post in threaded view
|

Re: Cannot build Slicer source after windows repair install

Tamas Ungi-2
I would try to build Slicer in a folder with short path length, like C:/S/D (6 characters)
(meaning Slicer buid in Debug version)
It will likely fail if the total path length is longer than 10 characters.

BTW, I think this email would be more appropriate on the slicer-devel list.

Tamas


-----Original Message-----
From: [hidden email] [mailto:[hidden email]] On Behalf Of vizproguy
Sent: June 24, 2014 9:02 PM
To: [hidden email]
Subject: [slicer-users] Cannot build Slicer source after windows repair install

Hi,

Unfortunately, I had to do a repair install of Windows, following which I can no longer build my source. Is there an easy way to get it compiling again?

So far, I installed CMake and added it to PATH. Also, I had a copy of PATH values for my old system, which I added to my current PATH. My Perl, Python and Qt installation folders seem to have been preserved just as they were before, so I did not reinstall/rebuild either of them.

Thanks,
Viz.



--
View this message in context: http://slicer-users.65878.n3.nabble.com/Cannot-build-Slicer-source-after-windows-repair-install-tp4027787.html
Sent from the slicer-users mailing list archive at Nabble.com.
_______________________________________________
slicer-users mailing list
[hidden email]
http://massmail.spl.harvard.edu/mailman/listinfo/slicer-users
To unsubscribe: send email to [hidden email] with unsubscribe as the subject http://www.slicer.org/slicerWiki/index.php/Documentation/4.3/FAQ


The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.

_______________________________________________
slicer-users mailing list
[hidden email]
http://massmail.spl.harvard.edu/mailman/listinfo/slicer-users
To unsubscribe: send email to [hidden email] with unsubscribe as the subject
http://www.slicer.org/slicerWiki/index.php/Documentation/4.3/FAQ